Todos os testes internacionais da IG MARITIME são gratuitos para marítimos. Basta registar-se uma vez para guardar o seu progresso e preparar-se sem limites.

CD7055. TOTS 1C-Operation, monitoring, machinery

Pesquisar nesta secção

Escolha um conjunto de perguntas e comece a estudar ou faça um exame de treino.

Sobre este conjunto

Na secção Seagull CBT encontra perguntas para estudo autónomo. Escolha um conjunto para estudar ou fazer um exame de treino.

«Seagull CBT — CD7055. TOTS 1C-Operation, monitoring, machinery» contém 76 perguntas em 1 conjunto.

Estudo

O modo de estudo não tem limite de tempo. Depois de responder, pode ver a avaliação e as opções corretas. Pode voltar a uma pergunta e repetir um tema.

Exame de treino

Um exame de treino dura até 60 minutos e inclui até 50 perguntas do conjunto selecionado. As soluções e os resultados aparecem no fim.

Exemplos de perguntas e respostas

Estes exemplos fazem parte do conjunto. Escolha Estudo para praticar pergunta a pergunta ou Exame de treino para testar os seus conhecimentos.

If the safety valves fitted on an air reservoir can be isolated from the reservoir, then..

Uma resposta correta

  • the reservoir must be fitted with a fusible plug.✓ Resposta correta
  • the safety valve must be fitted with a fusible plug.
  • the compressor must be fitted with a fusible plug.
  • it can be used legally without any added safety measures.
What is the most common cause of the lowering in performance of heat exchangers?

Uma resposta correta

  • Fouling of the heat transfer surface.✓ Resposta correta
  • An air lock.
  • Low water flow.
  • The division plate joint failure.
During discharge, problems with the inert gas plant result in the production of clean inert gas being reduced by 50%. What do you do?

Uma resposta correta

  • Advise the Chief Officer so that he can reduce the discharge rate in line with the reduction of the gas supply.✓ Resposta correta
  • Adjust the boiler controls to increase the fuel and reduce the air in an attempt to reduce the oxygen content of the gas.
  • Allow the discharge to continue as the oxygen content in the tanks may not rise significantly during the remaining discharge period.
  • Shut down the discharge until the inert gas system problem is resolved.
In plate type coolers you would normally expect the plates to be made of..

Uma resposta correta

  • titanium.✓ Resposta correta
  • silver.
  • stainless steel.
  • nickel brass.
The cause of an abnormally high condenser pressure within a refrigeration system would be..

Uma resposta correta

  • incondensable gases in the refrigerant.✓ Resposta correta
  • a low cooling water flow through the condenser.
  • a defective thermal expansion valve.
  • an above normal level of refrigerant in the condenser.

Antes de começar

Preciso de me registar para começar?

Pode aceder como visitante durante 23 minutos. Registe-se gratuitamente para continuar, guardar o progresso e rever os erros.

Em que idioma estão as perguntas?

As perguntas e opções mantêm o idioma original. Pode alterar separadamente o idioma da interface.

Posso usar o resultado como documento oficial?

Não. É uma prática autónoma. O resultado não substitui um exame, certificado ou avaliação de uma entidade autorizada.