Todos os testes internacionais da IG MARITIME são gratuitos para marítimos. Basta registar-se uma vez para guardar o seu progresso e preparar-se sem limites.

CD0420. Lockout Tagout

Pesquisar nesta secção

Escolha um conjunto de perguntas e comece a estudar ou faça um exame de treino.

Sobre este conjunto

Na secção Seagull CBT encontra perguntas para estudo autónomo. Escolha um conjunto para estudar ou fazer um exame de treino.

«Seagull CBT — CD0420. Lockout Tagout» contém 10 perguntas em 1 conjunto.

Estudo

O modo de estudo não tem limite de tempo. Depois de responder, pode ver a avaliação e as opções corretas. Pode voltar a uma pergunta e repetir um tema.

Exame de treino

Um exame de treino dura até 60 minutos e inclui até 50 perguntas do conjunto selecionado. As soluções e os resultados aparecem no fim.

Exemplos de perguntas e respostas

Estes exemplos fazem parte do conjunto. Escolha Estudo para praticar pergunta a pergunta ou Exame de treino para testar os seus conhecimentos.

You are going to work on equipment that has been isolated, but which was previously pressurised or full of fluid. Which TWO of these precautions should be followed? Select the TWO best answers.

Várias respostas corretas

  • Use any drain and vent valves fitted, checking that they are clear.✓ Resposta correta
  • Loosen the bolts at off flanges but leaving the nuts on. Then just break the joint at the flange.✓ Resposta correta
  • Give the isolating valves extra force with a wheel key.
  • Fully open a flange at the top of the equipment first.
How can safe isolation be maintained when more than one person is working on the same system, for instance in dry-dock? Select the ONE best answer.

Uma resposta correta

  • Each person should apply their own locks at the points of isolation.✓ Resposta correta
  • There should be a verbal agreement to check with each other before restoring the equipment to service.
  • One person should agree to take charge of the situation.
  • They should leave the locking arrangements to the Master or Chief Engineer.
If the equipment you are working on can move downwards under gravity, what should you do to keep safe? Select the ONE best answer.

Uma resposta correta

  • Make sure that it is securely locked into position or properly supported.✓ Resposta correta
  • Always work from above it.
  • Make sure that no-one can walk underneath it.
  • Only do the job when in port, so that the ship is not rolling.
If the person that applied the lock and tag out to a system is not available, what should be done when work is completed? Select the ONE best answer.

Uma resposta correta

  • Follow the on board procedure for such an event.✓ Resposta correta
  • The Chief Engineer or Chief Mate will remove them.
  • Anyone who has been involved in the work can remove them.
  • Leave them in place till the original person is available.
You have been working on electrical, pneumatic or hydraulic equipment. What should be done about the controls for the equipment before re-energising it? Select the ONE correct answer.

Uma resposta correta

  • The controls should be put into a safe position, usually the ‘off’ position.✓ Resposta correta
  • The controls should be checked to make sure they are in the same position they were when the work started.
  • Nothing needs to be checked, the equipment is not likely to start.
  • The controls should be placed to the ‘on’ position.

Antes de começar

Preciso de me registar para começar?

Pode aceder como visitante durante 23 minutos. Registe-se gratuitamente para continuar, guardar o progresso e rever os erros.

Em que idioma estão as perguntas?

As perguntas e opções mantêm o idioma original. Pode alterar separadamente o idioma da interface.

Posso usar o resultado como documento oficial?

Não. É uma prática autónoma. O resultado não substitui um exame, certificado ou avaliação de uma entidade autorizada.