Svi međunarodni probni testovi na platformi IG MARITIME besplatni su za pomorce. Registrirajte se jednom da biste spremili napredak i vježbali bez ograničenja.

CD0360. Crude oil tankers, Control of flow rates during loading

Pretraži ovaj odjeljak

Odaberite skup pitanja i započnite učenje ili probni ispit.

O ovom skupu

U odjeljku Seagull CBT dostupna su pitanja za samostalnu pripremu. Odaberite skup pitanja za učenje ili probni ispit.

„Seagull CBT — CD0360. Crude oil tankers, Control of flow rates during loading” sadrži 14 pitanja u 1 skupova.

Učenje

Učenje nema vremenskog ograničenja. Nakon odgovora dobit ćete povratnu informaciju i točne opcije. Možete ponoviti pitanje ili temu.

Probni ispit

Probni ispit traje do 60 minuta i uključuje do 50 pitanja iz odabranog skupa. Rješenja i rezultati prikazuju se nakon završetka.

Primjeri pitanja i odgovora

Primjeri su iz objavljenog skupa. Odaberite učenje za vježbu redom ili probni ispit za provjeru znanja.

According to SOLAS, who should control closing and opening of the valves on the inert gas distribution line? Select the ONE correct answer.

Jedan točan odgovor

  • The officer in charge of the cargo transfer✓ Točan odgovor
  • The Master, or the appointed deputy if ashore
  • The duty rating when checking for cargo leaks on deck
  • The Chief Engineer or the appointed deputy
During loading, which of the following must be monitored particularly closely while venting through a terminal’s vapour return line? Select the TWO correct answers.

Više točnih odgovora

  • Cargo tank vapour pressure✓ Točan odgovor
  • Cargo loading rate✓ Točan odgovor
  • Cargo vapour temperature increase
  • Vapour growth in the cargo tank
Which of the following factors are used to determine the size and venting capacity of a cargo oil tank pressure-vacuum valve? Select the TWO best answers.

Više točnih odgovora

  • The design loading rate✓ Točan odgovor
  • Vapour growth during loading✓ Točan odgovor
  • The height of the pressure-vacuum valve above the deck
  • The horizontal distance between the inert gas inlet and the pressure/vacuum valve
How can the contents of a cargo tank that is not being loaded be checked to see whether or not the ullage is changing during loading? Select the TWO best answers.

Više točnih odgovora

  • Set the high and low level alarm close to either side of the ullage of the tank and monitor closely✓ Točan odgovor
  • Check that any ullage change can be explained by changes in trim, list or temperature✓ Točan odgovor
  • Check that the loading rate for the tank is always shown as zero on the on-line loading instrument
  • Check to see that the ullage remains constant; any change would indicate tank leakage
During loading, there is a small but continuous change in the ullage of a filled tank not involved in the loading operation. What is the most likely cause? Select the ONE best answer.

Jedan točan odgovor

  • The hydraulic suction valve for the tank has crept open very slightly✓ Točan odgovor
  • There has been an increase in cargo temperature
  • There has been a change of trim
  • There has been a change of list

Prije početka

Trebam li se registrirati prije početka?

Pristup za goste traje 23 minuta. Besplatno se registrirajte za nastavak, spremanje napretka i pregled pogrešaka.

Na kojem su jeziku pitanja?

Pitanja i ponuđeni odgovori ostaju na izvornom jeziku. Jezik sučelja možete promijeniti zasebno.

Mogu li koristiti rezultat kao službeni dokument?

Ne. Ovo je samostalna vježba. Rezultat ne zamjenjuje ispit, potvrdu ni provjeru znanja ovlaštene ustanove.