Svi međunarodni probni testovi na platformi IG MARITIME besplatni su za pomorce. Registrirajte se jednom da biste spremili napredak i vježbali bez ograničenja.

CD0152. Hatch Cover Maintenance - Bulk Carrier

Pretraži ovaj odjeljak

Odaberite skup pitanja i započnite učenje ili probni ispit.

O ovom skupu

U odjeljku Seagull CBT dostupna su pitanja za samostalnu pripremu. Odaberite skup pitanja za učenje ili probni ispit.

„Seagull CBT — CD0152. Hatch Cover Maintenance - Bulk Carrier” sadrži 107 pitanja u 1 skupova.

Učenje

Učenje nema vremenskog ograničenja. Nakon odgovora dobit ćete povratnu informaciju i točne opcije. Možete ponoviti pitanje ili temu.

Probni ispit

Probni ispit traje do 60 minuta i uključuje do 50 pitanja iz odabranog skupa. Rješenja i rezultati prikazuju se nakon završetka.

Primjeri pitanja i odgovora

Primjeri su iz objavljenog skupa. Odaberite učenje za vježbu redom ili probni ispit za provjeru znanja.

You are carrying out maintenance on number 3 hatch cover. The permanent set has reached half the design compression in places and there are signs of wear. You have cut out two metres of bad seal along the port side. What length of rubber will you actually cut to insert in its place?

Jedan točan odgovor

  • 2.06 m✓ Točan odgovor
  • 2 m
  • 1.94 m
  • 2.03 m
  • 1.97 m
In a four-panel arrangement, the cylinders are operated once the cleats are all released, causing the first, or “leading” pair of panels to peak. At this time, what is happening to the second pair of panels?

Jedan točan odgovor

  • The wheels of the “trailing pair” roll up onto their trackways✓ Točan odgovor
  • They are also “peaking” in parallel
  • Nothing is happening to the second pair of panels. They are totally independent
  • The third panel is raised at 45 degrees and the fourth is about to begin elevating
The immediate effects of improper penetration into the hatch seal by the compression bar are shown below. Drag and drop the applicable effect onto the corresponding type of improper penetration.Izvorna slika nije dostupna.

Pitanje je dostupno u učenju i pretraživanju. Bez provjerenog ključa ne ulazi u ispit.

Izvorni podaci nemaju provjeren ključ odgovora

Izvorni elementi zadatka
  • Damage to the seal rubber and rapid failure of the seal
  • Seawater can get past the seal
What will an inspection prior to discharge primarily establish?

Jedan točan odgovor

  • Whether the measures taken in sealing the hatch after loading were successful✓ Točan odgovor
  • Whether there is any damage to the hatch cover panels
  • Whether there is any damage to the trackway
  • Whether the checklist completed after loading was correctly filled out
  • Whether the hatch was closed properly
  • Whether there was unusually heavy weather on passage
When replacing the straight pieces of a hatch seal, what is the recommended additional percentage to be allowed when cutting?

Jedan točan odgovor

  • 3 %✓ Točan odgovor
  • None, it should be cut to the exact length required
  • 1 %
  • 5 %
  • It should be undercut by 3 % and stretched during fitting

Prije početka

Trebam li se registrirati prije početka?

Pristup za goste traje 23 minuta. Besplatno se registrirajte za nastavak, spremanje napretka i pregled pogrešaka.

Na kojem su jeziku pitanja?

Pitanja i ponuđeni odgovori ostaju na izvornom jeziku. Jezik sučelja možete promijeniti zasebno.

Mogu li koristiti rezultat kao službeni dokument?

Ne. Ovo je samostalna vježba. Rezultat ne zamjenjuje ispit, potvrdu ni provjeru znanja ovlaštene ustanove.