Svi međunarodni probni testovi na platformi IG MARITIME besplatni su za pomorce. Registrirajte se jednom da biste spremili napredak i vježbali bez ograničenja.

CD0041. Generator

Pretraži ovaj odjeljak

Odaberite skup pitanja i započnite učenje ili probni ispit.

O ovom skupu

U odjeljku Seagull CBT dostupna su pitanja za samostalnu pripremu. Odaberite skup pitanja za učenje ili probni ispit.

„Seagull CBT — CD0041. Generator” sadrži 34 pitanja u 1 skupova.

Učenje

Učenje nema vremenskog ograničenja. Nakon odgovora dobit ćete povratnu informaciju i točne opcije. Možete ponoviti pitanje ili temu.

Probni ispit

Probni ispit traje do 60 minuta i uključuje do 50 pitanja iz odabranog skupa. Rješenja i rezultati prikazuju se nakon završetka.

Primjeri pitanja i odgovora

Primjeri su iz objavljenog skupa. Odaberite učenje za vježbu redom ili probni ispit za provjeru znanja.

Which control mode is recommended during manoeuvring?

Jedan točan odgovor

  • Optimal, because this mode allows an increased load of the generators during manoeuvring
  • Equal, because of the wider control range which allows the low priority generator(s) to be connected at low loads✓ Točan odgovor
  • Cyclic, because the risk of fouling of intake channels are eliminated, and because of this the risks of reduced capacity of the generators are minimised
What will happen if Load dependent start/stop of generator sets is in auto mode?

Jedan točan odgovor

  • It will start/stop the generator sets in response to varying load✓ Točan odgovor
  • It will start/stop the generator sets in response to fuel consumption
  • It will start but never stop the generator sets in response to varying load
  • It will stop but never start the generator sets in response to varying load
The kW and kVAr instruments on the main switchboard reads respectively 630 kW and 400 kVAr. What is the actual power factor?

Jedan točan odgovor

  • 0.8
  • 0.85✓ Točan odgovor
  • 0.9
How could you monitor the correct instant for synchronising without the aid of a synchroscope or synchronising lamps?

Jedan točan odgovor

  • By connecting a pair of voltmeter probes across one phase of the incoming generator circuit breaker, and then adjusting the generator speed until the voltmeter slowly fluctuates from zero to maximum. Connect the breaker when the voltmeter passes through zero✓ Točan odgovor
  • It is not possible to synchronise generators without the synchronising aids
  • By off-loading the running generator to a minimum to avoid large "kicks" at connection. Adjust the incoming generator to a frequency slightly less than the running generator. The running generator will then "pull" the incoming generator into synchronism
Which statement is true?

Jedan točan odgovor

  • The Priority 1 generator will be first IN / first OUT
  • The Priority 1 generator will be first IN / last OUT✓ Točan odgovor
  • At Cyclic control mode the generators change Priority order

Prije početka

Trebam li se registrirati prije početka?

Pristup za goste traje 23 minuta. Besplatno se registrirajte za nastavak, spremanje napretka i pregled pogrešaka.

Na kojem su jeziku pitanja?

Pitanja i ponuđeni odgovori ostaju na izvornom jeziku. Jezik sučelja možete promijeniti zasebno.

Mogu li koristiti rezultat kao službeni dokument?

Ne. Ovo je samostalna vježba. Rezultat ne zamjenjuje ispit, potvrdu ni provjeru znanja ovlaštene ustanove.