Libre para sa lahat ng marino ang mga internasyonal na pagsasanay sa IG MARITIME. Magparehistro nang minsan para ma-save ang progreso at makapaghanda nang walang limitasyon.

CD0007. Inert Gas Generator

Maghanap sa seksyong ito

Pumili ng pangkat ng mga tanong at magsimulang mag-aral o kumuha ng pagsusulit.

Tungkol sa pangkat na ito

May mga tanong sa Seagull CBT para sa sariling pag-aaral. Pumili ng pangkat para magsimulang mag-aral o kumuha ng pagsusulit.

May 75 tanong sa 1 pangkat ang “Seagull CBT — CD0007. Inert Gas Generator”.

Pag-aaral

Walang timer sa pag-aaral. Makikita ang resulta at tamang sagot pagkatapos sumagot. Maaari mong balikan ang tanong at ulitin ang paksa.

Pagsusulit

Hanggang 60 minuto at 50 tanong mula sa napiling pangkat ang pagsusulit. Makikita ang mga tamang sagot at resulta kapag tapos na.

Mga halimbawang tanong at sagot

Galing sa pangkat na ito ang mga halimbawa. Piliin ang Pag-aaral para isa-isahin ang mga tanong, o Pagsusulit para suriin ang kaalaman mo.

What is the SOLAS requirement regarding non-return devices in the inert gas main for inert gas systems on oil tankers?

Isang tamang sagot

  • There must be at least two devices one of which should be a water seal type.✓ Tamang sagot
  • There must be at least two water seal type devices fitted.
  • There must be at least two neither of which should be a water seal type.
  • As long as there is a water seal no other devices are required
When considering an independent, oil fired inert gas generator suitable for service onboard an oil tanker what are the SOLAS requirements for the oxygen content of the inert gas supply?

Isang tamang sagot

  • A maximum of 5%.✓ Tamang sagot
  • A maximum of 8%.
  • A maximum of 11%.
  • A maximum of 3%.
When considering the automatic operation of an independent inert gas generator the start up sequence normally has delays built in to ensure correct timing of the sequence. For example there will be a delay in the sequence to ensure sufficient furnace purging time. How can these delays be ensured in manual mode?

Isang tamang sagot

  • By the use of timed interlocks which operate even in the manual mode.✓ Tamang sagot
  • The operator is relied upon to ensure the correct timing of the sequence.
  • The delays are only an extra safety precaution so it doesn’t matter if they missed out.
  • There is no need for any delays if the operator is in attendance during start up.
When considering an independent, oil fired inert gas generator, other than providing a vent to the atmosphere during start up of the plant, what is the other main purpose of the automatic atmospheric vent valve?

Isang tamang sagot

  • It is used in conjunction with the inert gas main valve to regulate the pressure in the inert gas main.✓ Tamang sagot
  • It acts as an inlet for fresh air to the system when gas freeing.
  • It acts as the main relief device in the event of overpressure.
  • It is used to control the capacity of the inert gas generator.
Which of the given options is the one that will most influence the combustion efficiency for the burner type described in this module?

Isang tamang sagot

  • Distance from the main burner tip to the edge of the air cone.✓ Tamang sagot
  • Distance from main burner tip to pilot burner tip
  • Distance from pilot burner tip to igniter.
  • Distance from pilot burner tip to edge of air cone.

Bago magsimula

Kailangan bang magparehistro bago magsimula?

May 23 minutong guest access. Magparehistro nang libre para magpatuloy, ma-save ang progreso at balikan ang mga pagkakamali.

Anong wika ang gamit sa mga tanong?

Nananatili ang orihinal na wika ng mga tanong at opsyon. Puwedeng baguhin nang hiwalay ang wika ng interface.

Maaari bang gamiting opisyal na dokumento ang resulta?

Hindi. Para sa sariling pagsasanay ito. Ang resulta ay hindi kapalit ng pagsusulit, sertipiko o pagtatasa ng awtorisadong organisasyon.