Todas las pruebas internacionales de IG MARITIME son gratuitas para los marinos. Regístrate una vez para guardar tu progreso y prepararte sin límites.

CD7055. TOTS 1C-Operation, monitoring, machinery

Buscar en esta sección

Elige una colección de preguntas y empieza a estudiar o haz un simulacro de examen.

Sobre esta colección

La sección Seagull CBT ofrece preguntas para preparar la prueba por tu cuenta. Elige una colección para estudiar o hacer un simulacro de examen.

«Seagull CBT — CD7055. TOTS 1C-Operation, monitoring, machinery» contiene 76 preguntas en 1 colección.

Estudio

El modo de estudio no tiene límite de tiempo. Tras responder, puedes ver el resultado y las opciones correctas. Puedes volver a una pregunta y repetir el tema.

Simulacro

Un simulacro dura hasta 60 minutos e incluye hasta 50 preguntas de la colección elegida. Las soluciones y los resultados aparecen al terminar.

Ejemplos de preguntas y respuestas

Estos ejemplos pertenecen a la colección. Elige Estudio para practicar en orden o Simulacro para comprobar tus conocimientos.

If the safety valves fitted on an air reservoir can be isolated from the reservoir, then..

Una respuesta correcta

  • the reservoir must be fitted with a fusible plug.✓ Respuesta correcta
  • the safety valve must be fitted with a fusible plug.
  • the compressor must be fitted with a fusible plug.
  • it can be used legally without any added safety measures.
What is the most common cause of the lowering in performance of heat exchangers?

Una respuesta correcta

  • Fouling of the heat transfer surface.✓ Respuesta correcta
  • An air lock.
  • Low water flow.
  • The division plate joint failure.
During discharge, problems with the inert gas plant result in the production of clean inert gas being reduced by 50%. What do you do?

Una respuesta correcta

  • Advise the Chief Officer so that he can reduce the discharge rate in line with the reduction of the gas supply.✓ Respuesta correcta
  • Adjust the boiler controls to increase the fuel and reduce the air in an attempt to reduce the oxygen content of the gas.
  • Allow the discharge to continue as the oxygen content in the tanks may not rise significantly during the remaining discharge period.
  • Shut down the discharge until the inert gas system problem is resolved.
In plate type coolers you would normally expect the plates to be made of..

Una respuesta correcta

  • titanium.✓ Respuesta correcta
  • silver.
  • stainless steel.
  • nickel brass.
The cause of an abnormally high condenser pressure within a refrigeration system would be..

Una respuesta correcta

  • incondensable gases in the refrigerant.✓ Respuesta correcta
  • a low cooling water flow through the condenser.
  • a defective thermal expansion valve.
  • an above normal level of refrigerant in the condenser.

Antes de empezar

¿Tengo que registrarme para empezar?

Puedes acceder como invitado durante 23 minutos. Regístrate gratis para seguir, guardar el progreso y revisar tus errores.

¿En qué idioma están las preguntas?

Las preguntas y las opciones conservan su idioma original. Puedes cambiar el idioma de la interfaz por separado.

¿Puedo usar mi resultado como documento oficial?

No. Es una práctica independiente. El resultado no sustituye un examen, certificado o prueba de una entidad autorizada.