Todas las pruebas internacionales de IG MARITIME son gratuitas para los marinos. Regístrate una vez para guardar tu progreso y prepararte sin límites.

CD0231. High Voltage, Ship's electrical networks

Buscar en esta sección

Elige una colección de preguntas y empieza a estudiar o haz un simulacro de examen.

Sobre esta colección

La sección Seagull CBT ofrece preguntas para preparar la prueba por tu cuenta. Elige una colección para estudiar o hacer un simulacro de examen.

«Seagull CBT — CD0231. High Voltage, Ship's electrical networks» contiene 35 preguntas en 1 colección.

Estudio

El modo de estudio no tiene límite de tiempo. Tras responder, puedes ver el resultado y las opciones correctas. Puedes volver a una pregunta y repetir el tema.

Simulacro

Un simulacro dura hasta 60 minutos e incluye hasta 50 preguntas de la colección elegida. Las soluciones y los resultados aparecen al terminar.

Ejemplos de preguntas y respuestas

Estos ejemplos pertenecen a la colección. Elige Estudio para practicar en orden o Simulacro para comprobar tus conocimientos.

Which one of the following best describes why the overall system power factor is important when operating electrical generators on a ship?

Una respuesta correcta

  • It determines the total current that the generators must produce for a given active power✓ Respuesta correcta
  • It determines the kilowatt load on the generators
  • It determines the fuel consumption of generators
  • The overall system power factor cannot safely exceed 0.95
Which one of the following best describes why physical forces can be created from the interaction of 2 magnets?

Una respuesta correcta

  • The magnets move to make the lines of magnetic flux as short as possible✓ Respuesta correcta
  • The magnets move because of an electrical charge stored within them
  • The magnets move to even out the flux density
  • The magnets move if the lines of magnetic flux are forced to cross
High voltage ships tend to use earthed neutral electrical networks. Which one of the following best describes how excessive fault currents are prevented in the event of an earth fault on these ships?

Una respuesta correcta

  • An impedance is placed in the neutral earthing line✓ Respuesta correcta
  • The risk of earth faults is reduced by extra planned maintenance
  • Earth leakage circuit breakers are used on every circuit
  • An impedance is placed in each output cable from the generators
The kilowatt load on the ship’s only running generator is steady but the power factor meter shows a fall from 0.9 to 0.75. Which one of the following best describes the risk that this change in power factor poses for the ship’s electrical network?

Una respuesta correcta

  • The increase in apparent power may cause an overcurrent trip to operate✓ Respuesta correcta
  • The fuel consumption of the generator will be increased and the fuel could run out before arrival in port
  • The decrease in reactive power could cause supply cables to get hotter
  • The galley stove might burn out
Which one of the following options best describes why each feed normally leaves the section boards in a ship’s electrical network via some form of isolation?

Una respuesta correcta

  • To allow for maintenance on the circuit✓ Respuesta correcta
  • To allow motors to be stopped remotely
  • To allow lights to be switched off remotely
  • To protect against slow overloads

Antes de empezar

¿Tengo que registrarme para empezar?

Puedes acceder como invitado durante 23 minutos. Regístrate gratis para seguir, guardar el progreso y revisar tus errores.

¿En qué idioma están las preguntas?

Las preguntas y las opciones conservan su idioma original. Puedes cambiar el idioma de la interfaz por separado.

¿Puedo usar mi resultado como documento oficial?

No. Es una práctica independiente. El resultado no sustituye un examen, certificado o prueba de una entidad autorizada.