Svi međunarodni probni testovi na platformi IG MARITIME besplatni su za pomorce. Registrirajte se jednom da biste spremili napredak i vježbali bez ograničenja.

EN-IEB.AEN / OE2, OE3 / 5

Pretraži ovaj odjeljak

Odaberite skup pitanja i započnite učenje ili probni ispit.

O ovom skupu

U odjeljku ANR dostupna su pitanja za samostalnu pripremu. Odaberite skup pitanja za učenje ili probni ispit.

„ANR — EN-IEB.AEN / OE2, OE3 / 5” sadrži 37 pitanja u 1 skupova.

Učenje

Učenje nema vremenskog ograničenja. Nakon odgovora dobit ćete povratnu informaciju i točne opcije. Možete ponoviti pitanje ili temu.

Probni ispit

Probni ispit traje do 60 minuta i uključuje do 50 pitanja iz odabranog skupa. Rješenja i rezultati prikazuju se nakon završetka.

Primjeri pitanja i odgovora

Primjeri su iz objavljenog skupa. Odaberite učenje za vježbu redom ili probni ispit za provjeru znanja.

Which of the following is not a characteristic of AC motors?

Jedan točan odgovor

  • high torque at low speed✓ Točan odgovor
  • lower cost
  • less maintenance required
  • physically smaller than DC motors of the same horsepower
The timer element of a reverse power relay cannot be energized unless

Jedan točan odgovor

  • one generator is fully motorized
  • the movement of the disk is damped by a permanent magnet
  • the power flow is the same as the tripping direction✓ Točan odgovor
  • the power flow is the opposite to the tripping direction
A strain-relief device must be provided where a cord enters an appliance. The purpose of this device is:

Jedan točan odgovor

  • to provide for extra insulation between the cord and the metal case.
  • to maintain the flexibility of the cord.
  • to prevent the cord from being pulled out of the appliance.✓ Točan odgovor
  • to reduce the severity of a potential electric shock.
A semiconductor is a material with a

Jedan točan odgovor

  • conductivity higher than a normal conductor
  • conductivity higher than a normal insulator✓ Točan odgovor
  • high conductivity at low temperatures
  • low conductivity at high temperatures
Which of the following statements concerning the maintenance of solid-silver contacts in relays and auxiliary control circuits is correct?

Jedan točan odgovor

  • When necessary, they should always be dressed with a wire wheel.
  • They should be filed with a fine-cut file when projections extend beyond the contact surface.✓ Točan odgovor
  • When black silver oxide is present, it should always be removed from the contact surface with coarse sandpaper.
  • If necessary, they should be held together with moderate pressure while emery paper is drawn between the contacts.

Prije početka

Trebam li se registrirati prije početka?

Pristup za goste traje 23 minuta. Besplatno se registrirajte za nastavak, spremanje napretka i pregled pogrešaka.

Na kojem su jeziku pitanja?

Pitanja i ponuđeni odgovori ostaju na izvornom jeziku. Jezik sučelja možete promijeniti zasebno.

Mogu li koristiti rezultat kao službeni dokument?

Ne. Ovo je samostalna vježba. Rezultat ne zamjenjuje ispit, potvrdu ni provjeru znanja ovlaštene ustanove.