Svi međunarodni probni testovi na platformi IG MARITIME besplatni su za pomorce. Registrirajte se jednom da biste spremili napredak i vježbali bez ograničenja.

EN-IEB.AEN / OE1 / 6

Pretraži ovaj odjeljak

Odaberite skup pitanja i započnite učenje ili probni ispit.

O ovom skupu

U odjeljku ANR dostupna su pitanja za samostalnu pripremu. Odaberite skup pitanja za učenje ili probni ispit.

„ANR — EN-IEB.AEN / OE1 / 6” sadrži 53 pitanja u 1 skupova.

Učenje

Učenje nema vremenskog ograničenja. Nakon odgovora dobit ćete povratnu informaciju i točne opcije. Možete ponoviti pitanje ili temu.

Probni ispit

Probni ispit traje do 60 minuta i uključuje do 50 pitanja iz odabranog skupa. Rješenja i rezultati prikazuju se nakon završetka.

Primjeri pitanja i odgovora

Primjeri su iz objavljenog skupa. Odaberite učenje za vježbu redom ili probni ispit za provjeru znanja.

A four-pole induction motor, operating on three-phase 60 cycle current will operate at approximately

Jedan točan odgovor

  • 850 RPM
  • 1,150 RPM
  • 1,750 RPM✓ Točan odgovor
  • 3,550 RPM
Which of the following represents the accepted method of cleaning dust and foreign particles from electrical equipment while limiting damage to electric components?

Jedan točan odgovor

  • Carefully wiping off the components with a soft cotton rag.
  • Blowing a high velocity stream of compressed air rapidly across the components.
  • Using a vacuum cleaner to remove debris from the components.✓ Točan odgovor
  • Using carbon tetrachloride as a cleaning solvent to clean the components.
The torque produced by a motor when its shaft will not turn, even though rated voltage is applied to the stator, is known as

Jedan točan odgovor

  • locked-rotor torque✓ Točan odgovor
  • pullout torque
  • breakdown torque
  • torque margin
The speed of a multi-speed, squirrel-cage, induction motor operating in a fixed frequency system can be changed by

Jedan točan odgovor

  • reconnecting stator windings for different numbers of poles✓ Točan odgovor
  • changing the RPM of the rotor flux
  • changing the phase sequence of the applied voltage
  • reconnecting the stator so that no poles have the same polarity
During start-up of the circuit shown in the illustration EL-0081, it is noted that the ends of component "C" alternately glow and become dark without the tube illuminating The most probable cause for this is thatIlustracija pitanja

Jedan točan odgovor

  • component "D" is loose and due to the ship's vibrations makes and breaks contact
  • the power system's voltage is fluctuating in and out of the range necessary for proper operation
  • component "A" is shorted and therefore unable to produce the high voltage required to start the lamp✓ Točan odgovor
  • component "B" contacts are opening and closing thus prohibiting sufficient current flow

Prije početka

Trebam li se registrirati prije početka?

Pristup za goste traje 23 minuta. Besplatno se registrirajte za nastavak, spremanje napretka i pregled pogrešaka.

Na kojem su jeziku pitanja?

Pitanja i ponuđeni odgovori ostaju na izvornom jeziku. Jezik sučelja možete promijeniti zasebno.

Mogu li koristiti rezultat kao službeni dokument?

Ne. Ovo je samostalna vježba. Rezultat ne zamjenjuje ispit, potvrdu ni provjeru znanja ovlaštene ustanove.